ERATV Help System

Technical Characteristics: On-Board CCS Equipment

This section form contains information about the Command and Control Systems (CCS) on board the Vehicle Type:

• 4.13.1 Signalling
  • “4.13.1.1 ETCS equipment on-board and its level”: the user must select a single value from a predefined list shown on selection. If the value is set to “None”, then parameters 4.13.1.2, 4.13.1.3 & 4.13.1.4 are cleared and disabled.
  • “4.13.1.2 ETCS baseline.version (x.y)”: the user must select a single value from a predefined list. Additionally the user may provide a version as additional data.
  • “4.13.1.3 ETCS on-board equipment for reception of infill-function information via loop or GSM-R”: the user must select a single value from a predefined list.
  • “4.13.1.4 ETCS national applications implemented (NID_XUSER of Packet 44)”: the user may select multiple values from a predefined list.
  • “4.13.1.5 Class B or other train protection, control and warning systems installed”: the user may select multiple values from a predefined list. Additionally the user may enter a version where applicable.
  • “4.13.1.6 Special conditions implemented on-board to switch over between different train protection, control and warning systems”: the predefined list of available values is generated dynamically based on the selected values of parameters 4.13.1.1 & 4.13.1.5. The user has the option to check multiple values.
• “4.13.2 Radio”
  • “4.13.2.1 GSM-R equipment on board and its version (FRS and SRS)”: the user must select a single value from a predefined list. Selecting the value “None” will cause parameters 4.13.2.2 to be cleared and disabled.
  • “4.13.2.2 Number of GSM-R mobile sets in driving cab for data transmission”: the user may select a single value from a predefined list.
  • “4.13.2.3 Class B or other radio systems installed (system and, if applicable, version)”: the user may select multiple values from a predefined list. Additionally the user may enter additionally a Version number for each selected value.
  • “4.13.2.4 Special conditions implemented on-board to switch over between different radio systems”: the predefined list of available values is generated dynamically based on the selected values of parameters 4.13.2.1 and 4.13.2.3. The user has the option to select multiple values.

The selected values for parameters 4.13.1.1 and 4.13.1.5 are used to determine the second Configuration setting parameter (CCS on board). Making alterations to either of these parameters might cause data loss further down the registration process. A warning message will be presented to the user when an alteration to these values is performed.

The user may fill in any of the provided technical characteristics or perform any of the actions that are described in Step 2 help page. The next page in the technical characteristics fill in process is the Energy Supply page.

See Also

• Step 2
• Energy Supply